Ferrari 355 Servicing In Cheshire & Manchester

For annual minor and major services, cam belt changes, ball joint replacements, engine and gearbox repairs and running issues.

We are specialists of this specific Ferrari 355 model and are very experienced in all common issues with this model.

The Ferrari F355 is a sports car built by Ferrari from May 1994 to 1999. It is an evolution of the Ferrari 348 and was replaced by the Ferrari 360. It is a mid-engined, rear wheel drive V8-powered two-seat coupe, targa, or convertible. Design emphasis for the F355 was placed on significantly improved performance, as well as drivability across a wider range of speeds and in different environments (such a low-speed city traffic.)
Apart from the displacement increase from 3.4 to 3.5 L, the major difference between the V8 engine in the 348 and F355 is the introduction of a 5-valve cylinder head. This new head design allowed for better intake permeability and resulted in an engine that was considerably more powerful, producing 380 PS (279 kW; 375 hp). The longitudinal 90° V8 engine was bored 2mm over the 348's engine (85 mm rather than 83 mm), resulting in the small increase in displacement. Engine internals are produced using lightweight materials; the connecting rods are forged in Ti6-Al-4V titanium alloy. The engine's compression ratio is 11:1 and it employed the Bosch Motronic M2.7 engine control unit in the 1995 model year, which was then changed to the M5.2 in 1996 through end of production. The Motronic system controlled the electronic fuel injection and an ignition systems, with a single spark plug per cylinder. Engine lubrication is via a dry-sump oiling system.
The frame is a steel monocoque with tubular steel rear sub-frame with front and rear suspensions using independent, unequal-length wishbones, coil springs over gas-filled telescopic shock absorbers with electronic control servos and anti-roll bars. The car allow selection between two damper settings, "Comfort" and "Sport". Ferrari fitted all road-going F355 models with Pirelli tires, size 225/40ZR 18 in front and 265/40 ZR 18 in the rear. Although F355 was equipped with power-assisted steering (intended to improve low-speed drivability relative to the outgoing 348), this could optionally be replaced with a manual steering rack setup by special order.

Aerodynamic design for the car included over 1,300 hours of wind tunnel analysis. The car incorporates a Nolder profile on the upper portion of the tail, and a fairing on the underbody that generates negative lift when the car is at speed.
The car's standard seats are upholstered with hides from Connolly Leather, and are fitted asymmetrically in the car; this results in the driver being slightly closer to the car's center line than the passenger.
At launch, two models were available: the coupe Berlinetta priced at $130,000 (£78,000), and the targa topped GTS. The Spider (convertible) version, priced at $137,000 (£82,500), was introduced in 1995. In 1997 the Formula One style paddle gear shift electrohydraulic manual transmission was introduced with the Ferrari 355 F1 (note the dropping of the F before the 355) adding £6,000 to the dealer asking price. The F355 was the last in the series of mid-engined Ferraris with the Flying Buttress rear window, with lineage going back to the 1965 Dino 206 GT, unveiled at the Paris Auto Show.
The nomenclature does not follow the formula from the previous decades, i.e. engine capacity (in liters) followed by number of cylinders (e.g. 246 = 2.4 litres + 6 cyl, 308 = 3.0 litres + 8 cyl, and same for the 328, 348). For the F355, Ferrari used engine capacity followed by the number of valves per cylinder (355 = 3.5 litres engine capacity and 5 valves per cylinder) to bring the performance advances introduced by a 5 valve per cylinder configuration into the forefront. The F355 is relatively common as Ferraris go with 11,273 total units produced.






AE Performance Engineering Cheshire

Ferrari Independent Specialists For 355 Models

Only 30 mins from Manchester, Liverpool, Preston, Blackburn, Bolton, Bury, Chester, Wrexham, Wigan and only 60 mins from Leeds, Sheffield, Huddersfield, Stoke on Trent, Derby, Lancaster, Blackpool, Shrewsbury